Straight answers and careful work on metal roof installation in Fountain, NC. Metal roofing is our specialty, but we do the whole roof.
We have been setting metal panels on houses, churches, barns and additions for over twenty years, and the crews serving Fountain install them the same way we always have. Straight lines, correct fastener spacing, and closures at the ridge so wind driven rain has nowhere to go.
When a Fountain homeowner calls us about metal roof installation, the first thing we do is come look. Somebody from the crew gets on the roof, checks the decking, flashing and fasteners, and works out what the job actually needs before a number is ever written down.
You get a written estimate for the metal roof installation on your Fountain home with the materials named and the price broken out, and that estimate is free. If we find something once the work starts, we stop, show you, and price it before we go any further.
What to expect once you call us out to look at your roof.
Panel type comes first — standing seam or exposed fastener — then color, then trim. We walk you through the trade offs on each one.
If the shingles are coming off, they come off, and every board underneath gets checked before anything new goes down.
We keep panels straight to a line rather than to the eye, because a metal roof shows every bit of drift the moment the sun hits it.
Every penetration gets a proper boot or flashing instead of a bead of sealant and a hope.
Straight answers, no sales talk.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Fountain homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
Much less than people expect. Over solid decking with underlayment, a Fountain metal roof sounds about like a shingle roof from inside. The loud tin roof people remember was screwed to open purlins on a barn.
Most Fountain metal roof jobs land between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off is involved. Standing seam runs higher than exposed fastener panels. We measure before we quote and the estimate is free.
A straightforward Fountain house is usually three to five days. A cut up roof with dormers, valleys and multiple pitches takes longer, because every panel and trim piece gets measured and fit on site.
Our reputation is just the roofs behind us.
"New gutters and guards after they did our roof. No more climbing up there every October to dig out pine needles by hand."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"They roofed our addition and tied in the porch that runs off it. One crew, one number to call, and every line of it matched up."